Syllabus for UG

Introduction

UG Gateway

Creating file

Design
An overview of NX

Curves
Introduction, Overview of curves, Points & point sets, Basic curves, Associative basic curves, Splines & conics, Additional curve options, Editing curves.

Sketch
Sketching in NX with the basics, working with sketches, Constraining sketches, dragging & animating sketch etc.

Expressions

Feature Modeling
Creation of primitives like block, cylinder, pad, hole, boss, pocket, slot, groove etc.

Additional Feature Modeling
Swept along guide, Body taper, Scale body, Offset face, Sew, Extract Geometry, Spherical corners, Sheet from body, Patch body, Simplify body, Wrap geometry, Copy & paste features, Feature sets
Replacing features, Knowledge fusion etc.

Free Form Modeling
Through points, from poles, from point cloud, ruled, through curves, through curve mesh, swept, N – sided, section, extensions, fillet surface, face blend, soft blend, bonded plane, offset surface, bridge, thicken sheet, trimmed sheet etc.

Drafting
Drafting fundamentals, Preparation for drafting, Creating drawings & views,
Creating linear dimensions
Creating radial dimensions
Creating notes & labels 

Drafting Additional Topics
Creating stepped section views, creating revolved section views, creating centerline symbols, creating other drafting symbols, Creating GD & T symbols, creating plots of drawings

Assemblies
Assembly Navigator, Bottom – up assemblies, Reference sets, Top – down assemblies, Mating conditions, Component arrays etc.

Advanced Assembly Techniques
Filtering techniques, Representations, Clearance Analysis, Weight management, Assembly sequencing & motion, Assembly cloning, Variable component positioning, Part families etc.

Analysis
Scenario for structures, Scenario for motion
            
NOTE: This is an abbreviated syllabus. Subject matter is flexible and can be changed in both content and day of coverage. Handouts and Exercises are completed to review each subject area   

Theory- 36 hours, Practical- 72 hours.
Course fees- 8,000/-